The abrasive belt polishing machine replaces pickling with an environmentally friendly and non-emission method to remove 98% of the oxide layer on the surface of the wire (raw material).
This machine uses a 5.5KW motor to make the turntable rotate 360° around the steel wire to ensure that the steel wire is in contact with the sanding belt. The sanding belt is driven by two rotating drums driven by 5.5KW to move tightly on the surface of the wire, so that the surface of the wire is slightly lightened. Cutting, generally the wire surface will be uniformly cut by 0.03mm, but when the abrasive belt is working, the continuous falling oxide scale is inserted between the sand grains and the abrasive belt will slowly fail, usually not more than 24 hours, in order to improve the abrasive belt’s Service life, put the steel brush sheller in front of the belt machine, not only to ensure that the steel wire is 100% removed from the oxide layer, but also to increase the use time of the belt 10 times.
The company recommends that the sand size of the abrasive belt be selected between 40 mesh and 240 mesh. The larger the mesh, the smoother the surface of the steel wire. The 240-mesh grit can make the surface of the steel wire as smooth as a mirror. The steel wire can be directly plated with bright chrome or galvanized. .
The abrasive belt polishing machine produced by our company has a simple structure. It only takes 1 minute to replace two abrasive belts. The belt positioning system is simple and flexible. The debugging time is only 10 minutes. The abrasive belt never moves or slides during use.
The abrasive belt polishing machine produced by our company is matched with 280 mesh abrasive belt to make the polished steel wire such as mirror smooth and delicate, directly chrome-plated or galvanized.
The abrasive belt polishing machine of our company can increase the drawing speed of low-carbon steel wire and produce ordinary black iron wire. The sand belt machine is used between the wire drawing machine and the shelling machine to form spiral stripes on the surface of the steel wire. The depth of the stripes is about 0.03mm. , The densely-covered stripes of these nebulae can make the steel wire enter the mold to carry better lubricating powder, so the drawing speed is generally increased by 30%. If the mold uses nano-coating, the exit speed of the 2mm steel wire can reach at least 20 m/s, and the 1mm steel wire The speed is at least 30 m/s. And the service life of the mold is usually 500 tons.
The abrasive belt polishing machine produced by our company is used to produce welding wire. The use of coated molds saves boron coating and drying, and the cost per ton of welding wire is reduced by 100 yuan.
The abrasive belt polishing machine produced by our company is used to produce stainless steel wire, which can be free of coating and drying, no weather interference, and cost savings of more than 50 yuan.
The abrasive belt polishing machine produced by our company is used to produce high-carbon steel wire without pickling, which meets the requirements of environmental protection.
